Nasiol PPF Guard Ceramic Coating for Paint Protection Films 50mL

Nasiol PPF Guard Ceramic Coating for Paint Protection Films 50mL

PPFGuard is a flexible nano-coating product that increases the performance of paint protection films. PPFGuard increases hydrophobicity, UV resistance, and maintenance properties of film-coated surfaces without spoiling the reflective or structural properties of glossy, matte, and satin films. 

PPFGuard is applied in two coats, one hour apart, and is recommended for professional detailers and PPF installers.

WHY PPF GUARD?

• Increases hydrophobicity, UV and chemical resistance for paint protection films.
• Lasts up to 18 months.
• Retains self-healing properties of self-healing PPF films.
• Recommended for professional detailers.
• Professional detailers: full PPF protection with two layers laid one hour apart.  No toppers needed.  Kit format saves money on shop supply expenses.

APPLICATION SURFACES

Nasiol PPFGuard is applicable to paint protection films (PPF) including: matte and transparent polyurethane (PU), high quality PVC films, and vinyls. Do not apply product on finishes including low quality PPF or PPF w/ bubbles, absorbent surfaces, temporary road films, interior window tint, or any other film without resistance to solvents.

APPLICATION

• For best results, ensure that the environment where the application will take place is as close as possible to the recommended levels of temperature and humidity (23°C and 50% relative humidity)
• Apply in a shaded area
• Only apply to surfaces that are not too cold or warm
• Wash your vehicle thoroughly and gently. If necessary, should the PPF surface is suitable, polishing treatments can be applied using silicone-free products.
• Dry the vehicle thoroughly to prevent water drops on the surface during application.
• Apply to areas 1m² at a time.
• Overlapping edges does not cause issues during application.
• Shake the product gently before use. Carefully remove the cap. Place the small suede cloth on the block applicator, and apply the necessary amount of product (depending on the size of the application area) onto the cloth. Recap the bottle in order to prevent air contact. Spread the product throughout the surface in horizontal and vertical movements.
• Using the enclosed microfiber cloth, carefully wipe any excess product off the surface within 30–60 seconds. Avoid causing swirls during this step. You can use a lighting system to ensure there is no product residue left on the surface. Following the application of the first layer, wait for 60 minutes, then repeat the steps for the second layer.
• Throughout the 24 hour curing time, keep the coated surface away from direct sunlight, excessive dust, water, and contaminants. The vehicle can be taken outdoors 24 hours after application. For the first 48 hours, do not wash the surface with shampoo or detergents. 

BOX CONTENT

• Nasiol PPFGuard Bottle
• Nasiol Applicator Block
• Nasiol Suede Cloths x5
• Nasiol Microfiber Cloth (Light Grey)
• Nitrile Gloves
• Nasiol Window Sticker
• Dropper
• Quick User Manual